Wood homemade deer feeder plans12/2/2023 A PVC cap of 6-inches diameter for the pipe.A 2.5 to 3 feet long PVC pipe with 6 inches diameter.A spray paint (camo green would be ideal).A piece of wood or lumber of around 10 x 10 inches.You will need to use a few tools, including a small spatula for the cement, a drill, a brush for the primer, and probably a saw to cut wood if needed. So if you are a hunter or a tracker, this type of feeder will come like a gem. This is very similar to the gravity feeder and among the most attractive for deer. Remember to adjust the feeder as well as you can to the anchoring points, so it doesn’t fall with hard winds or any type of weather condition. This explanation comes with all the details you’ll need. Gravity will do its job, and finally, deer will have somewhere to feed without problems. To add the food inside, just open the lid or the plug and stash the feeder until the food reaches half-way or top of the PVC tube. This will help to keep the feeder full even after several days. We recommend corn or any type of grain that’s cheap, and you can add in at least several pounds. To finish, you’ll just need to add the food inside. You can use ropes, ratchet straps, or even wire for this. Make sure it is adjusted well so the open side of the PVC wye points up at a nice height so deer can feed on it without problems. Lastly, tighten up the PVC tube strongly to a tree, post or fence. If you set it up well enough, no water should get inside. This will prevent rain or any sort of water-pouring climate effect to introduce water into the feeder and possibly damage the food. What you can do is use the plug or lid and set it on the top. Then it’s crucial to block water from entering. This also helps to allow water to drain down and stop the food from spoiling. This way you can prevent the food from slipping down with gravity. Now you need to set the grate at the bottom of the tube with a wye. Make sure the wye is in the bottom with the open side pointing up. Ratchet strap, ropes or wire (for securing the feeder)įirst, you will need to attach the wye to the PVC or large tube.A PVC or metal wye (should fit the width of the PVC tube).
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |